| | | |
|
|
|
|
Mike and Ed drill out the rivet holes - Nigel Bennett (nbennett) Viewed: 1015 times.
|
Firebox corner now prepared for riveting - Nigel Bennett (nbennett) Viewed: 951 times.
|
Preparing the safe end tubing - Nigel Bennett (nbennett) Viewed: 936 times.
|
Phil preparing to sand blast - Nigel Bennett (nbennett) Viewed: 978 times.
|
| | | |
| | | |
|
|
|
|
Cutting safe ends for super heater flues - Nigel Bennett (nbennett) Viewed: 1004 times.
|
All the safe ends are now cut - Nigel Bennett (nbennett) Viewed: 901 times.
|
Each end must be tapered to fit into the flue - Nigel Bennett (nbennett) Viewed: 940 times.
|
The taper is cut in the lathe - Nigel Bennett (nbennett) Viewed: 943 times.
|
| | | |
| | | |
|
|
|
|
New piston rod for the McCabe - Nigel Bennett (nbennett) Viewed: 922 times.
|
The tender tank top is now much improved - Nigel Bennett (nbennett) Viewed: 957 times.
|
Pressure tester for flues - Nigel Bennett (nbennett) Viewed: 960 times.
|
The piston rod is now back in the McCabe - Nigel Bennett (nbennett) Viewed: 903 times.
|
| | | |
| | | |
|
|
|
|
Removing stay caps - Nigel Bennett (nbennett) Viewed: 867 times.
|
Inside a flexible stay - Nigel Bennett (nbennett) Viewed: 953 times.
|
This where the element fits into the header - Nigel Bennett (nbennett) Viewed: 874 times.
|
Dennis welds the tube sheet - Nigel Bennett (nbennett) Viewed: 934 times.
|
| | | |
| | | |
|
|
|
|
Flues now ready for welding - Nigel Bennett (nbennett) Viewed: 933 times.
|
McCabe piston now back in place - Nigel Bennett (nbennett) Viewed: 952 times.
|
Paul cleaning super heater elements - Nigel Bennett (nbennett) Viewed: 961 times.
|
This is how the elements are tested - Nigel Bennett (nbennett) Viewed: 913 times.
|
| | | |